Overstock Balloons and Supplies

This page has been created to sell used or new equipment we no longer use or balloons we have way too many of. We are located in Kirkland, Washington. I can ship or ,if you are close, you may pick up by appointment. We take credit cards and, if you pick up, cash works, too! If you have a question
please email Dave at ttballoons@hotmail.com .

Used inflators
We have several older inflators for sale. Most don't have a gauge so you can't tell when you are low on helium. Most of them are hand-tite so you don't need a wrench. The push valves can come with a foil tip which you can use for blowing up either foils or some valved latex balloons. I have tested them and they
all work good.

Inflator 1 - $30.00 This push-valve is great for all sizes of balloons and comes with the foil tip, too. Also has a ribbon cutter and disk pin. This blows up balloons faster than a tilt valve. This is a hand-tite that is missing the plastic around the hand-tite part. You can still use it that way, though,by turning the rest with it when it gets tighter and then turning the inflator back to the right position.	Inflator 2 - $25.00 This is a tilt-valve hand-tite with gauge. Looks like a wrench tite but has the o-ring so you don't really need a wrench. No cutter or disk pin. The clear cover on the gauge is missing but it still works great.	Inflator 3 - $20.00 This is a hand-tite push valve that has a cutter but no gauge. Missing the plastic around the hand-tite part but still works. I'll include the foil tip and/or disk pin if you want. It screws in.
Inflator 4 - $20.00 This push-valve has cutter, disk pin and even the plastic around the hand-tite. I'll include the foil tip if you want it. It blows up balloons faster that a tilt valve.	Inflator 5 - $20.00 This hand-tite push-valve has cutter and I'll include the disk pin and foil inflator if you want them. It blows up balloons faster that a tilt valve.
Inflator 7 - $15.00 This is a wrench-tite tilt valve inflator. About as basic as it gets. You have to have a wrench to tighten it. There is no o-ring to seal it.